For automotive enthusiasts looking to elevate the look of their ride, our yellow DRL LEDs offer the perfect solution to radically transform the style of your BMW. This installation guide walks you through replacing your BMW’s daytime running lights (DRL), giving your car a personalized, modern edge. If you’re looking to change the color of your BMW’s Angel Eyes, be sure to check out our shop (MACOTE).
If you arrived here via one of our product pages, it means that this installation is compatible with your BMW. Unfortunately, we haven’t yet produced detailed instructions for every model, but this guide is designed to give you an in-depth understanding of how to change your DRL module. Follow these instructions, and you should be able to complete the installation successfully. As always, feel free to contact us anytime for assistance during your installation process.
Note: This guide is general. Vehicle designs vary, and certain steps may differ depending on your model. Always consult your vehicle’s manual if you have any doubts. Moreover, our DRLs are designed exclusively for OEM headlights and are not suitable for aftermarket setups.
Installation Presentation Video
Installation Process
Before you begin:
Ensure the ignition is off and the battery is disconnected to prevent any risk of electric shock or short circuits.
Step 1: Locate and Remove the DRL Module
Locate the DRL modules, typically mounted on the top or rear of the headlights. Unscrew the module using a T20 Torx screwdriver. On some vehicles, you might need to remove the bumper, fender, or even the wheels for better access.
Step 2: Detach the DRL PCB from the Heat Sink
Move the module to an appropriate work area. Identify the original thermal paste between the heat sink and the DRL electronic board. Using a craft knife, carefully separate the LED board from the aluminum. For some models, you might find it easier to use a thin screwdriver to gently push the PCB through the designated holes.
Step 3: Clean the Heat Sink
Once the board is removed, use a razor blade to scrape away any remaining thermal adhesive without damaging the aluminum. Clean the heat sink with isopropyl alcohol to remove any traces of thermal paste.
Step 4: Apply New Thermal Paste and Install the New DRL Module
Apply a line of thermal paste along the center of the back of the new LED PCB. Position the board on the heat sink, aligning the slots with the tabs. Apply even pressure and hold the board in place with clamps while the paste cures.
Step 5: Allow the Thermal Paste to Cure
Wait 1 to 2 hours for a full cure before moving on with the installation.
Step 6: Reassemble the DRL Modules
Remove the clamps and reconnect the modules to their respective connectors. Replace the module into the headlight housing and secure it with the T20 Torx screws—be careful not to overtighten, as this could damage the plastic housing.
Step 7: Enjoy the Final Result
Congratulations! Your new DRLs are installed. Take a moment to appreciate the transformed look of your vehicle. Whether you opted for a single-color version or an RGB model, your car now sports a unique, distinctive flair.
Conclusion
By following these steps, you can personalize your vehicle with our DRL modules. This guide is general and may require adjustments depending on your car model. At Macote, we’re here to help you transform your BMW into a head-turning masterpiece.